Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

usb ethernet or serial

Status
Not open for further replies.
Z

zmanultra

Member level 2
Member level 2
Joined
Mar 20, 2004
Messages
48
Helped
4
Reputation
8
Reaction score
2
Trophy points
1,288
Location
Australia
Activity points
524
hi guys,
im a new engineer in search of some experienced suggestions in regards to communication methods selection,
i need an opinion on choosing the most accurate (with least errors occurring) and fastest communication method. The board that im going to use has the following:

Gigabit Ethernet (1000 Mbps)
Ethernet Interface (10/100Mbps)
USB1.1
RS-232, RS422 or RS485, software configurable

thank you so much in advance
 

It depends on the device you need interfacing.

If you can choose the interface among the quoted ones, certainly you should choose Gigabit Ethernet since it is fastest. If you have more than one device and gigabit ethernet is busy you can :
1-Use a hub or switch
2-Use other interface available since the speed is suitable for you application.

If the device comes with an interface it is basically due to two reasons:
1- The interface is suitable for the device.
2- When the device was manufactered there was no better interface available for its purpose.
 

    Z

    zmanultra

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top