Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Track and hold simulatoin

Status
Not open for further replies.
W

wael_wael

Full Member level 4
Full Member level 4
Joined
Dec 3, 2005
Messages
221
Helped
5
Reputation
10
Reaction score
2
Trophy points
1,298
Activity points
2,760
Dears

could some one suggest me any any paper or tutorial for simulate the sample and hold, i have designed one but i still dont know how to test it. i got nice output but still i want make sure it is works as well.
regards
 

You can assemble an ideal T/H and run a sinewave through it and the actual design. Compare the ideal and actual design outputs and determine how many bits of accuracy are obtained. If you subtract the actual from ideal, you can get the non-idealities part of it (assuming they are all modelled) and then you have the actual signal to determine SNR.Hope that helps.
 

    W

    wael_wael

    Points: 2
    Helpful Answer Positive Rating
For distortation analysis, you can do fourier transform of the output. For AC analysis, you can just do the hold mode operation. The common mode of the input and output are defined so that you don't need to worry about the DC bypass feedback.
 

    W

    wael_wael

    Points: 2
    Helpful Answer Positive Rating
transient simulation and FFT for distortion
 

    W

    wael_wael

    Points: 2
    Helpful Answer Positive Rating
thank so much, i will do that and tell you what is the result
thanx again for ur help
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top