Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Eagle does not give consistence between schematic and board

Status
Not open for further replies.
B

boncker

Member level 2
Member level 2
Joined
Dec 9, 2006
Messages
51
Helped
3
Reputation
6
Reaction score
1
Trophy points
1,288
Location
Brazil
Activity points
1,610
eagle part not found in board

Guys,

I am working in Eagle software to make a schematic and switching to the board to place the components in correct place. So, I checked all inconsistences warnings but with 2 components it can not add to the board from schematic. See ERC message below:


Parts not found in board:
D2
REDE_60HZ


D2 (a diode) and REDE_60Hz (a pin) don't go to the board.

Anyone can help me how to include these D2 and REDE_60Hz on the board?

Thanks!
 

eagle update board from schematic

- delete these two components from the schematic
- be sure to have the board opened in the background
- place again the two components into the schematic
- do an ERC

another possibility if you didn't route anything in the board yet:
- close the board
- delete the *.brd file
- open the schematic if necessary
- switch to the board. As there is no board file, a new one will be created
 
  • Like
Reactions: Naponus

    B

    boncker

    Points: 2
    Helpful Answer Positive Rating
    N

    Naponus

    Points: 2
    Helpful Answer Positive Rating
eagle not found in board

M!k,

I deleted the .brd file and did all again. Now it's running ok.

Thanks!
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top