Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

how to introduce S parameters in CST?

Status
Not open for further replies.
S

sami273

Newbie level 6
Newbie level 6
Joined
Apr 26, 2006
Messages
13
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,395
Hi everybody,
I have to simulate a lumped elements loaded antenna in CST Microwave Studio. The used lumped elemenets are defined by S parameters.
Could CST accept this kind of mixture simualtion?

regards,
Sami
 

Can you elaborate a bit more? Is it the generator load? or is it a termination like in a leaky-wave antenna?
You can always go the other way, meaning: Extract the S-parameters of the antenna as a Touchstone file and use it in a microwave circuit software (MWoffice, ADS etc.)

Good luck,
P.
 

    S

    sami273

    Points: 2
    Helpful Answer Positive Rating
You can do this with CST Design Studio by importing a touchstone file of the lumped elements in Design Studio and co-simulating it with Microwave Studio.

aw
 

    S

    sami273

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top