Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

simvision and SDF file

Status
Not open for further replies.

mathi

Junior Member level 2
Junior Member level 2
Joined
May 18, 2006
Messages
23
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,452
Hi all,

I am trying to do post-layout simulation using simvision. I have extracted the SDF file from encounter. Can someone tell me how i can include the SDF file in the simulation.

Thanks.
 

Dear Mathi

As far as i know differnt simulators have different commands to include the SDF file for post layout simulation. The best way to know more and in details is by reading manual. Please go through the manual.

suresh
 

    mathi

    Points: 2
    Helpful Answer Positive Rating
look nc-sim user mannual and search “sdf", there is some command which open and read you sdf file.
 

    mathi

    Points: 2
    Helpful Answer Positive Rating
Hi,
In tools there is an option for compiling sdf file, once it is done it will generate an output file which it will use in simulation. In commond line also u can do the same thing.
 

if you are using ncverilog,

add +sdf_file<arg> Specifies the SDF annotation file
+sdf_orig_dir Put compiled sdf file in same location as original sdf file
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top