noloser
Junior Member level 1
ml403 datasheet
Hi all,
I am a student. I am new to verilog and FPGA.
I have a question.
How do I use the 16x2 LCD which is on the development board?
I have a verilog code which I want the LCD to load the ASCII char from
the verilog code I written. The verilog code is just a few shift
register acting like a LUT (look up table).
Is there any way i can control the 16x2 LCD or is there any macro?
I realize that the LCD i/o is connected to the GPIO so is there any way
i can use the on board LCD and how?
Thanks in advance.
Hi all,
I am a student. I am new to verilog and FPGA.
I have a question.
How do I use the 16x2 LCD which is on the development board?
I have a verilog code which I want the LCD to load the ASCII char from
the verilog code I written. The verilog code is just a few shift
register acting like a LUT (look up table).
Is there any way i can control the 16x2 LCD or is there any macro?
I realize that the LCD i/o is connected to the GPIO so is there any way
i can use the on board LCD and how?
Thanks in advance.