Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello. If I know the device's S22 value , how can I make sure the output impedence of the device? e.g. the S22 is 0.41∠30 ， what is the output impedence? THS!
the S-Parameter are always refer to a certain port impedance (50 Ohm most of the time). You not only need the S-Parameter, you also need the referece impedance to calcualte the Z and Y Parameter.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
