Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Basic S-parameter problem

Status
Not open for further replies.
C

CQCQ

Member level 3
Member level 3
Joined
Nov 26, 2006
Messages
61
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Visit site
Activity points
1,721
Hello. If I know the device's S22 value , how can I make sure the output impedence of the device? e.g. the S22 is 0.41∠30 ， what is the output impedence? THS!
 

Hi,

the S-Parameter are always refer to a certain port impedance (50 Ohm most of the time). You not only need the S-Parameter, you also need the referece impedance to calcualte the Z and Y Parameter.

F.
 

    C

    CQCQ

    Points: 2
    Helpful Answer Positive Rating
Hello,



Attached documents on S-Parameter basics for Modeling Engineers (SPAR_4_MdlgEng_ppt.pdf)...
Specifically page 4 & 5, very useful for you...


---manju---
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top