Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How to measure antenna bandwidth?

Status
Not open for further replies.
K

Kin

Newbie level 4
Newbie level 4
Joined
Oct 18, 2005
Messages
5
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,328
measure bandwidth using hfss

Hi,

How do I measure the -3dB bandwidth of an antenna in HFSS?
Is it by plotting the S11 and obtain the bandwidth from there? If yes, do I measure the bandwidth with reference to the -3dB point on the S11 curve? Or is it some other reference point?

Also, in real-life measurements, how can I measure my antenna bandwidth using a network analyzer?

I would really appreciate it if anyone could give me advice on this.

Thanks in advance.
 

antenna bandwidth

In usual case, we refer the antenna impedance bandwidth with respect to -10dB return loss bandwidth.

Regards,
 

    K

    Kin

    Points: 2
    Helpful Answer Positive Rating
s11 10db bandwidth

Asdfaaa !

If you have a VNA (vector network analyzer) you can measure the first and the lat point of frequency where they below -10dB (or greater then |10dB|) this will be your BW of the antenna !!!

About the HFSS - look for the plots of the farfield - from there you can see the BW or you can do exaclty what I've just told you with the VNA - with the S11 graph of the HFSS.

Bye.
 

Does this mean that it is the same in HFSS and when I'm using a network analyser, that is, I can measure my antenna bandwidth from the S11 curve (return loss) with respect to the -10dB point?

Can anyone explain why it is at -10dB? Does -10dB at the S11 plot correspond to the half-power point (i.e. -3dB)? If yes, how is it related?

Thanks very much for all your replies!! :)
 

Hello Kin !

About your 1st quest. : The -10dB of R.L. is an acceptable level of value to describe the loss of the power which reflects back from the antenna (and not radiated). For example, a -16dB (or -15dB) is acceptable value to describe matched device like filter or amplifer to the system - in Antenna 10dB is sufficent (or higher)
About the relation with the -3dB : the -3dB points are the half power points (in linear vlaue) the -10 dB is calculated as follow:

Inv Log [-10/20]=0.31 which means that 1-0.31=0.69 of power ratio goes throw the antenna (insted of half - 0.5 which disspited or reflected back).

Good Day !
Hoped Its helpful,

Itzik
 

    K

    Kin

    Points: 2
    Helpful Answer Positive Rating
Hi "itzikhaim" and "asdfaaa",

Thanks very much for all your help. I have a better understanding now.

:D :D :D :D :D
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top