Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

What's the best condition for getting the best ADC readings?

Status
Not open for further replies.

Peder

Junior Member level 1
Junior Member level 1
Joined
Aug 3, 2005
Messages
17
Helped
1
Reputation
2
Reaction score
0
Trophy points
1,281
Activity points
1,409
When using an ADC of a microcontroller, what would be the best conditions to get the best reading. Eg. What osc. would be best and would another osc. on the same board give allot of noise.

Thank you
 

Re: ADC Question...

Sampling frequency is ADC dependent, ADC inputs have to be shieleded by a ground island. even the track resistance can induce an error
 

    Peder

    Points: 2
    Helpful Answer Positive Rating
Re: ADC Question...

you can use adc0809 work about 600khz, if you want a program example i have it to SDCC Compiler to wirk with 8051 microcontroller
 

    Peder

    Points: 2
    Helpful Answer Positive Rating
ADC Question...

u'll need to take care on both software and hardware sides. on software side , take readings samples and average out for proper reading.
 

    Peder

    Points: 2
    Helpful Answer Positive Rating
Re: ADC Question...

if u are using ADC 0808 then it needs 500khz..also if u are interfac with microcontroller 89c51,then from the ALE pin u can take the clock and divide the clock using some flipflop and make 500kz.
 

    Peder

    Points: 2
    Helpful Answer Positive Rating
Re: ADC Question...

Hai...if u want accurate results for ADC try to get more samples and take the average of that..I hope it would be better instead of taking one value and starting calculations
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top