Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
process corner r of four types generally u face during the simulation
this is due to the manufacturing defect.
they r slow slow, fast fast, typical,typical,slowfast, fast slow.
depending upon the process corner our gain and every thing changes
thats it
multifingered technology means dividing thelarge nmos to smaller nmos with same w but differnt l because current distribution is not uniform in the large mos structure.
ok thank u
hope this woiuld be helpful to u
According to me . We check for four corners , FF , SS , SF, FS . Since TOX is not uniform through out die . So our circuit should work at any place of die . we check our circuit parameters at all corners like Fast , Slow and Typical .
Regarding Multi fingers to have better matching. and uniform distribution of current .
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
