Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

how can i set the lumped port for ltcc capacitor?

Status
Not open for further replies.
L

lynne

Newbie level 4
Newbie level 4
Joined
Oct 14, 2006
Messages
7
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,320
I draw a embedded multilay capacitor ,then i
set two lumped port at each side of capacitor,but when use the formule
c=-1/(2*pi*freq*im(Z(11))),
I got nagetive value .
how can i solve this problem?
 

I guess your C equation is incorrect.
please try:
C=im(Y11)/(2*pi*freq)
 

thank you
but the two formules express the same mean and value .
 

lynne said:
thank you
but the two formules express the same mean and value .
Click to expand...

Those two formular represent different meaning, Y(1,1) is not equal to 1/Z(1,1).

For two lumped ports simulation, you need check whether two ports share common reference ground plane.

Regards,
 

    L

    lynne

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top