Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

how to determine cap and switch sizes in SC CMFB ?

Status
Not open for further replies.
You may refer to CMFB chapter in the book
Analog IC Design, Ken Martin & David Johns
 

    J

    jeffsky520

    Points: 2
    Helpful Answer Positive Rating
To SengYee88: I have look through that books, but no detail info for cap and switch size design. Look forwarding to your advise about that. Thanks anyway.
 

Hi,
You may refer to pg 291 of the book. Chapter 6.7 Current feedback opamps.
It is difficult to tell how much cap is needed, as it varies according to the opamp speed and current drive.

Basically, the SC form a R, that you would need to know how much R you need and hence design the C according to the SC theory.
h**p://www.swarthmore.edu/NatSci/echeeve1/Ref/FilterBkgrnd/SwitchedCap.html

Hope it helps.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top