Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

RS232C or RS485 for a thousand feet long network

Status
Not open for further replies.
S

siteplayer

Newbie level 6
Newbie level 6
Joined
Aug 16, 2006
Messages
14
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
0
Dear ALL

I have 4 microcontrollers that are to be networked with wire length of abt. a thousand feet.
I just want to ask can it be done with RS232C interface? or I shud it be done with RS485?

AKSAHT MEHRA
 

Re: Question on RS232C

It could be done with RS232 if you really want it, but with RS485 will be much easy. With RS232 you need an addressable daisy chain scheme with an RS232 transciever and two RS232 connectors on every board.
 

Re: Question on RS232C

You can use the serial communication port implemented in th uC units and use the SN75176 chip from national semiconductors as an RS485 transceiver. this approach can cover up to 1200 m (witn a maximum of 300 bps).

Hope this helps.
 

Re: Question on RS232C

what abt the external noise tolarence?
 

Re: Question on RS232C

16F676 said:
what abt the external noise tolarence?
Click to expand...
RS485 uses "differential" signal which is reasonably noise immune.

Mike
 

Re: Question on RS232C

Hi
Look the distance of communication for rs232 is dependent of baud rate
the for example you can communicat at 9600 for about 100m,and at 2400 may be
around 300m
if you need more than this distance you must chang to rs485
 

Re: Question on RS232C

RS485 is best choice
 

Re: Question on RS232C

HI
I think RS485 is a better choise. It is more convient for large distances.
 

Question on RS232C

you can use RS485
 

Question on RS232C

see AN on rs485 and rs422
 

Question on RS232C

CAN (Controller Area Network) if you don't mind the higher cost.
CAN-open and CAN-kingdowm are good bet.
 

Re: Question on RS232C

WHEN U WANT COMMUNICATION BETWEEN 4 CONTROLLERS THEN THE BEST OPTION IS RS-485
 

Re: Question on RS232C

siteplayer said:
I have 4 microcontrollers that are to be networked with wire length of abt. a thousand feet.
I just want to ask can it be done with RS232C interface? or I shud it be done with RS485?
Click to expand...

Check this ---> h**p://www.echip.co.in/rs232.html

RS232 is prone to noise. RS485 is differential driving and immune to common mode noise. You can drive up to 4000 Ft.

Hope this helps.

Cheers

Ravi
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top