Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Questions about the stabilty of a PA

Status
Not open for further replies.
dingjingfeng

dingjingfeng

Full Member level 3
Full Member level 3
Joined
Aug 12, 2005
Messages
189
Helped
17
Reputation
34
Reaction score
8
Trophy points
1,298
Activity points
2,243
linear PA which usually have two amplifying stages.
1. Should each of the stage have a stability factor K larger than unity? Or the K of the whole PA?
2. Should the K larger than unit in the low frequency range(<1MHz)?
3. How to simulation a large signal s parameter to find out the LSSP stability,
is there an example in ADS?
3ks
 

Re: stabilty of a PA

There are lot of examples available at the installation folder of Agilent ADS
 

    dingjingfeng

    dingjingfeng

    Points: 2
    Helpful Answer Positive Rating
Re: stabilty of a PA

For a multi-stage RF PA important is the total K stability factor.
The PA has to be stable for different output loads and phases, and also should be stable at low frequencies.
 

    dingjingfeng

    dingjingfeng

    Points: 2
    Helpful Answer Positive Rating
Re: stabilty of a PA

for multistage amplifier, i think each of stage should have stability factor K larger than unity. IMO, if each stage has K larger than unity, we can assure that total K larger than unity.

in my experience, total K larger than unity, doesnt guarantee that every single stage has K>1. so a single stage possibly experiences instability. instability of a single stage causes instability of PA.

regards
 

    dingjingfeng

    dingjingfeng

    Points: 2
    Helpful Answer Positive Rating
stabilty of a PA

I think both single stage and multistages k factor should be larger than unity.
 

Re: stabilty of a PA

I have to explain a little bit more.
First of all, if K factor is lower than unity doesn’t mean that the stage it will oscillate. That means the stage is potential unstable for different input/output impedances.
The changes of the impedances internally are not so significant compared to changing of impedances externally of the PA. So, the first priority is overall K factor.
 

Re: stabilty of a PA

K is not good enough for all cases, such as balanced amps and other structures. Look up "The S-Probe Approach to Amplifier Stability Analysis" from a guy at Triquint. Ansoft also developed a method; remember control theory class and drawing the spiral stability graphs.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top