Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

A question about digital module timing constraint!

Status
Not open for further replies.
P

precession

Newbie level 3
Newbie level 3
Joined
Sep 6, 2006
Messages
4
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,306
82_1158220766.JPG

Here is a depiction from Synopsys DC document.
But I really can not understand why "min = min_path - hold".
Let's think about the ideal case which the min_path equal to zero.
In this case, the output_delay value is negative.
Negative output_delay value means that the data could be changed unavailable before the clock’s active-edge. But how could that possible?
I can not understand. Who can explain it to me?
Thank you very much!
 

the hold value (0.4) is the new data available time after the posedge of clock.

If this value is 0, then mim output delay is just the min path delay out of chip.
so the constrained internal path delay inside chip is -min_delay.

If the hold value is greater than zero, it requires that the data should keep stable longer time, so the min path delay inside chip is -min_delay+hold, so the min output delay is just -(-min_delay+hold)= min_delay-hold . This constraint is more strictly than that of the case with hold value 0.
 

    P

    precession

    Points: 2
    Helpful Answer Positive Rating
Ah, I see, I see.
Sorry, I made a mistake.
Output_delay is the time needed before but not after the clock's active-edge.
So negative output_delay value exactly means the hold time after the active clock edge, when the the min_path equal to zero.
So, problem solved. Who can tell me how to delete this post?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top