Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

HELP: How to draw ribbon wire in HFSS V10

Status
Not open for further replies.
Kaiserh

Kaiserh

Newbie level 6
Newbie level 6
Joined
Mar 3, 2006
Messages
13
Helped
2
Reputation
4
Reaction score
0
Trophy points
1,281
Location
Frankfurt/Oder, Germany
Activity points
1,397
draw a ribbon in hfss

Hi,

I am tring to draw a ribbon wire in HFSS to simulate a wire-bond package.

The problem is I can only find two types of bondwire in HFSS (JEDEC 5-Point & JEDEC 4-Point) and my boss is not satisfied with these wires.

So, how can I draw ribbon wires in HFSS V10? (As my understanding, the ribbon wire should have a rectangular cross-section and a little bit curvy from side-look )

Thank you in advance!

Best regards,
K
 

1) Draw a polyline along the desired path of the wire. Both end segments should be perpendicular to your bond pad.

2) Draw a rectangular cross-section of the ribbon around the polyline. The cross-section should lie on the same plane as the bond pad.

3) Extrude (sweep) the cross-section along the path and assign a gold material (solve inside if needed).
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top