Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How to simulate the MOS C-V curve?

Status
Not open for further replies.
DZC

DZC

Full Member level 2
Full Member level 2
Joined
Sep 12, 2006
Messages
149
Helped
13
Reputation
26
Reaction score
5
Trophy points
1,298
Activity points
2,122
mos cv curve

Had any one done before？
 

cv curve of mos using cadence

What kind of your simulation software?
these are some my ideas:
+ use current source to supply current
series with NMOS
+Change Vgs from 0 -> Vsup

Probe Ids --> everything is done.
it's so easy

Added after 3 minutes:

What kind of your simulation software?
these are some my ideas:
+ use current source to supply current
series with NMOS
+Change Vgs from 0 -> Vsup

Probe Ids --> everything is done.
it's so easy
 

nmos cv curve

using Hspice
but how to indicate the Ig?
 

mos cv curves

Ig=0. N.P/MOS is controlled by voltage applied to Gate terminal.
There is only current flow from Drain to Source!
 

c-v curve simulation

Connect in series 2 DC sources:
One of them has Vdc=Vgate Vac=0
Another Vdc=0 Vac=1m
Use AC analysis and change Vg as sweeping parameter.
Then plot C= Ig/(2*Pi*Freq*Vgs) vs. Vgate. You will get CV curve.
I did that several times in Cadence. It works fine.
There is another method using transient with fixed frequency.
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top