Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Is it possible to make Oval drill Patterns in Protel DXP?

Status
Not open for further replies.
E

evl_inside

Member level 2
Member level 2
Joined
Aug 10, 2006
Messages
50
Helped
4
Reputation
8
Reaction score
1
Trophy points
1,288
Location
Mars
Activity points
1,555
Drill Pattern

Hello,

Is it possible to make Oval drill Patterns in Protel DXP. If yes then how?
 

Re: Drill Pattern

Yes you can. There are two ways.

1> Crude/Primitive method ....
Keep adding The required hole sise overlapping each other. It works fine.

2> Create a slot .

Refer to the fig attached. make sure you specify the XY location of slot WRT Origin.

Hope it helps.

Centiago
 

    E

    evl_inside

    Points: 2
    Helpful Answer Positive Rating
Re: Drill Pattern

Thanks for the Help.

Can you also suggest me where and how can I specify the XY Location of the Drill.
Is it to be done in the Gerber Data?

Devil.
 

Re: Drill Pattern

Just give X & Y location of center of semi circle one of the semicircle. Then specify the length of slot. Reffer to the pic I attached earlier.

Good Luck
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top