Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

What threads are the best for a PCB?

Status
Not open for further replies.
C

cyberblak

Full Member level 2
Full Member level 2
Joined
Jul 19, 2005
Messages
138
Helped
6
Reputation
12
Reaction score
0
Trophy points
1,296
Location
Canada
Activity points
2,618
pcb screw threads

Hi,

I need something screwed into a PCB and I need the threads to be sturdy enough so that they don't break when someone put too much torque on the screw.

Best solution is one that cost virtually nothing :D

Any idea, someone?

Thanks,

cyberblak
 

Re: Threads in a PCB

I've seen threaded pcb holes, but they were only meant to retain a captive screw - threads on the end and a smaller diameter round shaft below the head - your cheapest solution assuming you are using FR4 is PEM nuts - available from any hardware distributor - manufactured by PEM Industries, Captive Fasteners, and others - with versions specifically for use in PCB's.

SiGiNT
 

    C

    cyberblak

    Points: 2
    Helpful Answer Positive Rating
Re: Threads in a PCB

i too have used swagged in PEM's. They work well for me even at high currents. make sure the pull force of the screw is pulling the PEM into the board and not the other way round.

Good luck


dfullmer
 

Threads in a PCB

Yup, PEM's are the way to go.

I have not come across anything as cheap to use as a PEM.
 

Re: Threads in a PCB

Thanks to all...

This is exactly what I was after.

cyberblak
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top