Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

analog waveform in modelsim

Status
Not open for further replies.
D

dsp_forall

Member level 2
Member level 2
Joined
Jun 8, 2006
Messages
48
Helped
2
Reputation
4
Reaction score
1
Trophy points
1,288
Activity points
1,511
modelsim analog

can any one help to view analog wave form in modelsim

suppose i want to view 200 Hz sine wave as input data ??

thanks
 

modelsim analog simulation

if u were talking about modelsim in FPGA design simulation in no way u can do this ,the signal must be DIGITAL & depending on your design u can substitute the analog signal with releated digital signal ......
 

modelsim analog curve

ok if i want to give equivalent digital signal of analog .....how i can get those digital signals..


thanks in advance
 

wavweform bei modelsim

can u post more details about your design?
 

how to see analog waveform using modelsim

suppose i want to make filter say fir with cut off frequencies 250 Hz and if i give input data sum of three frequencies say 200 Hz 500 Hz and 1000Hz

i can get the output of only one frequency that is 200 Hz.

that i want to see in modelsim
 

how to see analog waveform in modelsim

ok plz correct me if i got u wrong
u made a digital filter , the input signal is digital having different frequencies & u wanna simulate a signal with varying frequencies on modelsim ?
 

how see sine waveform using modelsim?

yes correct
 

how see sine wave form using modelsim?

did u try to make the input signal as a clock(from modelsim) & change duty & period to the desired frequency

or ofcourse the sys clock must be the higher frequency then u can put additional block to force input cotrlled with clk divider to the desired frequency
 

cant see output signals modelsim

see we can force a clock but square wave has infinite frequencies ....verification problem
 

modelsim digital to analog

let me remind u ....the filter u made must be digital filter & hence u can't apply a compsite frequencies analog signal direct to the Digital filter without passing through ADC
note that digital filter is capable of filtering square waves
 

modelsim wave design

ok i did it ......i know that digital filter input is in digital form (say 8 bit ) ...

what i did is sample a composite signals in matlab and got samples ..and convert it in binary (8 bit) and applied to filter input .Now i changet the format of waveform window in modelsim to analog and i can view the analog waveform ..
set pixel setting according to your choice to get smooth output..

have a nice time and enjoy
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top