Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

questions about CMFB from Razavi's textbook

Status
Not open for further replies.
A

airboss

Member level 3
Member level 3
Joined
May 1, 2006
Messages
64
Helped
6
Reputation
12
Reaction score
2
Trophy points
1,288
Activity points
1,819
Hi,

I have questions about 2 examples on Razavi's book. They're on p.321 and p.322 and I attach the figures here.

In Figure 9.39, Razavi illustrates that if both Vout1 & Vout2 rise, the drain currents of M3 & M4 increases and Vout,CM decreases. What I don't understand is, why the increase of ID3 and ID4 causes the decrease of Vout,CM?

Also, in Figure 9.40, I know when Vout1 and Vout2 rise, the drain currents of M5, M6 decrease but why then Vout,CM is also lowered?

Thanks for any help!
 

Hello,

you can think of it in two ways:

1. As voltage, forget about the currents now, and check the path of small signal from CM sense and back to it, check wether the increase at some point will lead to increase or decrease on another "for common source it's inverting , for common gate it's non and so on."

2. As current, remember that as I increase for same W/L , Vgs must increase, but also Vds will change, Remember the Id vs Vds family of curves, at diff. Vgs, the curves had slope of 1/ro , for short channel ro is not so large, now draw the load line, you will find that as I goes up, so does Vgs but Vds will lower..
 

    A

    airboss

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top