Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Determining input impedance of CMOS in ADS

Status
Not open for further replies.

STOIKOV

Full Member level 4
Full Member level 4
Joined
Nov 18, 2005
Messages
236
Helped
8
Reputation
16
Reaction score
2
Trophy points
1,298
Activity points
3,083
is it possible to determine the input impedance of a cmos circuit in ADS by knowing the s11 or with other procedure ? for example in an amplifier or mixer.
 

Re: Input impedance

yeah for sure
u can in ads in sparameter simulation check the impedance claculation

u can fined the input impedance

khouly
 

    STOIKOV

    Points: 2
    Helpful Answer Positive Rating
Re: Input impedance

which steps should I follow ? work with an equation or with the help of some kind of plot ? regards
 

Re: Input impedance

it is easy in ads, ADD THE ZIN COMPONENT and do the simulation then you get the zin in the simulation result, thanks
 

    STOIKOV

    Points: 2
    Helpful Answer Positive Rating
Re: Input impedance

I'm sorry I cannot find that component, which pallet is it located ? I have 2003 version
 

Re: Input impedance

Hi

You should find it under "Simulation-S_Param".

Regards
 

    STOIKOV

    Points: 2
    Helpful Answer Positive Rating
Re: Input impedance

Stop using canned programs as a crutch!

If you already know S11, from a measurement or a simulation, then you already know the input impedance since S11=(ZL-Z0)/(ZL+Z0).
 

    STOIKOV

    Points: 2
    Helpful Answer Positive Rating
Input impedance

In smith option menu, change from "normalized" to 50 Ohm ( or other char. imp.) to see input impedance.
 

    STOIKOV

    Points: 2
    Helpful Answer Positive Rating
Re: Input impedance

in ADS uder S-parameters there is option to Zin component,,it will help you to determine the Zin, or you can select the Z-parameters from S-parameters simulator.....
 

    STOIKOV

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top