Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

What is metal density error and why we need to check metal density error?

Status
Not open for further replies.
P

p.sivakumar

Member level 1
Member level 1
Joined
Dec 29, 2005
Messages
35
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
1,617
Hi
What is metal density error and why we need to check metal density error ?

Thanks
Siva
 

Re: metal density

hi

it depends upon ur work or project.

actually it is measured so that we could guess the incertanity and poor performance of the object we want to make by this metal. usually it is necessary in mills and heavy machines
 

Re: metal density

Thats a good question i faced same question in interview but in different way..

if we have more parallel vias between two metals.. then the metal density will not be uniform...
Actually there must be some minium density in a metal.. according to drc rule.. if u have more parallel vias.. then in that place the metal density gets low as vias present more...
There must be some metal density for electrons to propagate...


Regards
Shankar
 

metal density

Another thing that brings about the metal density DRC rule is the fact that, mechanically, each layer of metal has to have a certain metal density in order for the chip to not have reliability issues due to mechanical damage resulting from heating/cooling and different therman coefficients of the various layers.
 
  • Like
Reactions: p_r_p

    P

    p_r_p

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top