Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
There are a lot of choices from very simple (resistor divider or zener diod reference) to complex step down switching regulators. The essential question is how much current (and/or power) you need at 5V side. Reply please.
The designer needs to clarify the current ratings of source and load .
ex: say 10amps load , none of the suggested solutions seem feasible .
For glitches /ripple at input /pulsed loads ,special design are needed.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
