Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How to choose the waveport size and the boundary size for bandgap transmission line?

Status
Not open for further replies.
B

bouchouicha

Newbie level 4
Newbie level 4
Joined
Apr 26, 2006
Messages
5
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,315
I am trying to build a bandgap transmission line(CPW (w=0.2mm,g=0.1mm,h=0.5mm,ξ=11.6)), but I donot think the result is correct espacially above 30 GHz. I think there are some problem in my defining of the size of waveport.

Could you help and tell me how to choose the waveport size and the boundary size, and also which kind of boundary should I choose, perfect E or perfect H?

Thank you very much!!!!
 

Re: size of waveport

If you are referring to HFSS analysis, the waveport for a CPW feedline must contact the side grounds in order to set up the proper modes on the line. The bottom boundary should extend down to the groundplane if it is grounded CPW and past the dielectric bottom if it is ungrounded CPW. The recommended port width is 3*(2g + w) and minimum port height is 4*h.

Be careful not to make the port width greater than λ/2 in any direction or a waveguide mode will also be supported.
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top