Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Questions about CMFB loop

Status
Not open for further replies.
safwatonline

safwatonline

Advanced Member level 4
Advanced Member level 4
Joined
Nov 19, 2005
Messages
1,341
Helped
219
Reputation
438
Reaction score
48
Trophy points
1,328
Location
EGYPT
Activity points
9,038
CMFB

hello,
i was checking the stability of a CMFB loop , so i tried using the stability analysis in Cadence i got the PM and GM, but i want to know the zero's and pole's for compansation,
my question is can i cut the loop in any node "and add AC source wth approximate DC of this point taken 4m transient analysis", or there is some kind of better nodes and is the approximate DC value is suffiecnt "note that the DC is varing
and i already suffer from oscillations"or should i expect wrong curves, also should i neglect the loading effect after cutting the loop?
thnx,
a.safwat
 

CMFB

1.Cut off a loop shall be keep the load effect as before cut off this loop, that mean the DC value shall be keep as before.
2. The better cut off node in the loop is the side of the node is the lowest output resistor and the other side of the node is the highest input resistor.
3. I think the simulation method of a opam can be a reference for you.
 

    safwatonline

    safwatonline

    Points: 2
    Helpful Answer Positive Rating
CMFB

hekoo zkkbmy,
what is the simulation methode of opam , is it a tuturial ,if so plz upload it.
thnx,
a.safwat
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top