Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

how to add a resistor model from a model card

Status
Not open for further replies.
ramy_maia

ramy_maia

Member level 2
Member level 2
Joined
Dec 9, 2005
Messages
46
Helped
2
Reputation
4
Reaction score
0
Trophy points
1,286
Activity points
1,663
AA
hello there
i am using cadence IC 5.141 and i want to add the tech. parameters to the resistors in my design i already have a TSMC 0.18 model card (.scs) whcich contains resistor corner model , but i don't know how to attach this model parameters to my design
thanx in advance
 

WA
did u try to do the same steps as in Transistors?
btw when i close the schematic and reopen it , i have to re-add the model card path again , cannot this step be automated?
thnx
 

    ramy_maia

    ramy_maia

    Points: 2
    Helpful Answer Positive Rating
safwatonline said:
WA
did u try to do the same steps as in Transistors?
btw when i close the schematic and reopen it , i have to re-add the model card path again , cannot this step be automated?
thnx
Click to expand...
by save state i think,from here another problem arises,,,when i save state,,and then re-open cadence again ,i found no saved states although i noticed a folder in the workspace called simulaton which contains i think the states i simulate
any suggestions?
thanks
 

    ramy_maia

    ramy_maia

    Points: 2
    Helpful Answer Positive Rating
AA,
ramy check the model card as pdf , then in page 14,15 there are like 10 model names for diffrent resistances try to see which one u want to use then add its name to the model name of an ordinary resistance from analog library
 

    ramy_maia

    ramy_maia

    Points: 2
    Helpful Answer Positive Rating
husseinadel said:
by save state i think,from here another problem arises,,,when i save state,,and then re-open cadence again ,i found no saved states although i noticed a folder in the workspace called simulaton which contains i think the states i simulate
any suggestions?
thanks
Click to expand...
very strange i save states just as you said and i still have them but you must load state of the same cell view you saved not another one
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top