Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

pad to drill size formulae

Status
Not open for further replies.
V

v_kumar

Full Member level 5
Full Member level 5
Joined
Jun 2, 2004
Messages
272
Helped
18
Reputation
36
Reaction score
3
Trophy points
1,298
Location
India
Activity points
1,964
help
can anyone tell me whether there is any formulae for drill size to pad size
how to decide the pad size.

e.g

if drill - 24mil
than pad - ? (how to decide it any formulae?)
 

Pad size calculation
min. P = (2 x R) + FA + D

P = Pad size
R = Annular ring
FA = Fabrication allowance
D = Drill or tool diameter

Details at: https://www.brockstedt.de/en/desi/padsize.html

Used units:
40 mil approx 1.00 mm
10 mil approx 0.25 mm
4 mil approx 0.10 mm

Regards,
IanP
 

    V

    v_kumar

    Points: 2
    Helpful Answer Positive Rating
hi,

It again depends on the complexity of the board,for 24 mil drill min 10 mil more can be added,especially for via.

If it is for any components, then we need to add more say 15 r 20 mil depends upon the requirement,for reliabliity.

Hope this will help u.


Regards

Ramesh
 

Is there any similar formulae for
SOLDER MASK
AND PASTE MASK

THANKS
 

SOLDER MASK:

Swell solder mask 13 mil (.013) larger than the Pad, SMT or Non-Plated hole size.
If LPI (liquid photo image-able) solder mask is required swell to 5 mil (.005).
Click to expand...

**broken link removed**

Regards,
IanP
 

    V

    v_kumar

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top