Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Process Information for 0.18um

Status
Not open for further replies.
F

faraday_3

Newbie level 3
Newbie level 3
Joined
Feb 19, 2006
Messages
4
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,321
cmos process parameters 0.18um

Can anyone please tell me the following parameters for CMOS 0.18um process?
For nMOS and pMOS:
- KP (for beta=KP*W/L in uA/V^2)
- Vth

I am using TSMC 0.18um. I also looked for them in the documents provided by TSMC without any luck

Regards,

Faraday.
 

kp values for tsmc 0.18um

faraday_3 said:
Can anyone please tell me the following parameters for CMOS 0.18um process?
For nMOS and pMOS:
- KP (for beta=KP*W/L in uA/V^2)
- Vth

I am using TSMC 0.18um. I also looked for them in the documents provided by TSMC without any luck

Regards,

Faraday.
Click to expand...

Hi,
MOSIS has process specification data for TSMC 0.18 um for each run.

Here is the link :

**broken link removed**

Click on any of the runs to get the values that you want.

Bharath
 

tsmc process specification 0.18

I have worked on TSMC 0.18u process following are the values u required :

Kn is between 182u to 225u (ss to ff)
Kp is between 54u to 65u (ss to ff)

Vthn = 0.68V to 0.88V (ff to ss)
Vthp = -0.6V to -0.8V (ff to ss)

all the parameters for 3.3V device.
 

Uo of NMOS is about 0.0459 m^2/Vs
Uo of PMOS is about 0.0109 m^2/Vs
vthn is about 0.445 (TT)
vthp is about -0.438 (TT)
for 1.8v MOSs
 

    F

    faraday_3

    Points: 2
    Helpful Answer Positive Rating
Dear zhancangF117 :

Differencel circuit has difference value,
When you know the range of these parameter,
you need to calcuate them again for your design.


Regards,
mpig09
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top