Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

What should be the thickness of dielectric to make 2mm gap?

Status
Not open for further replies.
neena

neena

Member level 4
Member level 4
Joined
Feb 6, 2006
Messages
77
Helped
9
Reputation
18
Reaction score
4
Trophy points
1,288
Location
pluto
Activity points
1,762
layout cross section

hi

i am working with a four layer board
and the gap between the inner layer should be 2mm gap
how much did i have to give the thickness of dielectric
Is there any standard values to be assign


thank u
regards.......
 

Re: layout cross section

Hi Neena,

If you are talking about controlled impedance board,then you need to tell the pcb fabricators regarding the Board Impedance(like 75 100ohms etc).Rest fabricator will take care.Hope this will help you.And you can ask any fabricators for information.Hitech in bangalore may provide details your looking for...

Regards

Rame
 

    neena

    neena

    Points: 2
    Helpful Answer Positive Rating
Re: layout cross section

normally the impedence requirement will define the spacing of the layers.
if impedence is not an issue then u can select ur own option.
i have attached one option here, also it depend on the fabricator too.
 

    neena

    neena

    Points: 2
    Helpful Answer Positive Rating
Re: layout cross section

hi

if impedance is not an issue
and i want the board thickness of 2mm
with copper foil thickness of 2oz
how to choose FR4 values

if for controlled impedance
how and what values to be used


regards
........
 

Re: layout cross section

here i have attached the layerstackup.
confirm with ur vendor will he able to select the dielectric with given thickness.

Binu G
 

    neena

    neena

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top