Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Spectre can do the noise analysis?

Status
Not open for further replies.

winsonpku

Advanced Member level 4
Full Member level 1
Joined
Jul 7, 2005
Messages
119
Helped
6
Reputation
12
Reaction score
0
Trophy points
1,296
Activity points
2,351
spectre noise analysis

As so many people said that hspice can't do the noise analysis of the fully differential amp,but i found that there is a .noise statement in the hspice manual,so what is the function of this statement.
And another question is that spectre can do the noise analysis of the fully differential amp?
 

noise analysis with spectre

I think what you need is an accurate noise model. The simulators should support noise analysis.
 

spectre ac analysis

SPICE can only do noise analysis on linear systems (including opamp), by the .noise system. For non-linear systems such as mixer, you can run spectre, by pnoise analysis.
 

spectre linear

tlihu said:
I think what you need is an accurate noise model. The simulators should support noise analysis.

Could you explain it in detail. Noise model is a seperate file or it's inclued in the process hspice model which is released by foundry.
And i didn't find the noise model information in hspice manual.
 

noise analysis using virtuoso spectre

There are small differences between HSpice and Spectre regarding the linear noise analysis.

1. Spectre could use a voltage difference between two nodes as a noise output.
2. Spectre could use a specific DC analysis or an arbitary transient point as operating point for the noise analysis.
 

    winsonpku

    Points: 2
    Helpful Answer Positive Rating
transient noise in spectre

Hspice can do noise analysis only in AC analysis.
Spectre can do that in both transient and AC analysis.
Actually Spectre is better for noise analysis.

You can use .noise only after .ac analysis in Hspice.
.noise analysis ouputs the total input or output referred noise as you point the input and output node.

Hspice CAN do noise analysis for fully differential amp in AC analysis.
 

    winsonpku

    Points: 2
    Helpful Answer Positive Rating
noise analysis in spectre

both of them can do noise analysis
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top