Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

having problem with 89c51rd2bn

Status
Not open for further replies.
S

sagar_dhavare

Newbie level 1
Newbie level 1
Joined
Jan 24, 2006
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,289
hey folks,

i have a board mounted with 89C51RD2BN .
i connected it to my pc via serial port (COM1).
The problem is in downloading my program's hex file in microcontroller.
I use Flash Magic v 2.48 ,
The problem is flash magic is unable to detect the µc.
when i start the job of downloading hex file it puts the error :-

Code: 
    Unable to connect at the specified baud rate. Try reducing the baud rate.
    Reset  the hardware into ISP mode again.

... reducing the baud rate doesn't work .
i could not figured out what is the problem.
this is my first real world program.

and need --- help
 

hai
check the following things
did you set the baud rate,crystal freq,microcontroller,comport?
did you connected to vpp
did you reseted the microcontroller before down loading?
is your com port,cable,max 232 on the microcontroller board and commection up to rx & tx of microcontroller is ok?power and ground of microcontroller is ok?
still the problem persists,replace the microcontroller

sunish
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top