Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Corrugated Horn design using the HFSS

Status
Not open for further replies.
A

Asim Ali Khan

Junior Member level 3
Junior Member level 3
Joined
Dec 12, 2005
Messages
25
Helped
2
Reputation
4
Reaction score
2
Trophy points
1,283
Activity points
1,471
corrugated horn

Salam All
I have to desing a corrugated horn antenna using the HFSS.I do not understand how can I make the corrugations.
Help me in this regard
 
corrugated horn+link

Salam All
Pls. help me in designing the corrugated horn.Any website link any thing !!!!!!!
Problrm is to design corrugations.PLs do something
in this regard
Thx in addvance
 
Corrugated Horn Desing

you could use slant meanderline and sweep around z axis.
 

I found the easiest way was to start with a piece of waveguide, and then stack a series of flat disc-like cylinders on top. Each alternate cylinder was either the inside shape of a recess, or of a ring ridge sticking into the vacuum. Then use the "Unite" tool to join them all together as a single shape. Them put an "air box" around the whole lot. Also, add excitation wave port at the input, and make the surfaces boundaries conductive. That's as far as I got. I messed up on trying to get the simulation to work - so far. You can also use a polyline - a series of lines joined to be the shape of the corrugation profile, and sweep it 360 degrees around an axis.
 

hi modeling in hfss is difficult but you can design with feko
if you want i can send you corrugated horn designed in feko
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top