Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

integration problem ..not directly applicable ..not easy too

Status
Not open for further replies.
Y

ysenthilece

Member level 3
Member level 3
Joined
Aug 15, 2005
Messages
56
Helped
2
Reputation
4
Reaction score
0
Trophy points
1,286
Location
india
Visit site
Activity points
1,962
x1+x2+x3=1 && x1+x2>x3 && x2+x3>x1 && x1+x3>x2

i need the total number of points satisfying all the above conditions (quantified as area formed )

this could be solved easily by using analytical geometry ...


but i need to generalise this for the case n variables of x..so i can't visualise and do ..

so is there some procedure to do the above problem so tat i could generalise it for the case n .

ie x1+x2+.....+xn=1 && x1+x2...........x(n-1)>xn .....so on

for n=4 it is a volume ...which could be calculated too with some difficulty....but i need for any n...
 

Re: integration problem ..not directly applicable ..not easy

sounds like a problem set by a teacher

my advice is not to use n factors

as this is an additive progression only

so n =1/x + 1/2x.... etc

as it is all calculated over 1 you then only need

to divide your 1/x{finaly x value} value by 100/n
 

Re: integration problem ..not directly applicable ..not easy

Just wanna assue you that the matrix B is easy to get. Actually, B consists of only two numbers in the whole matrix, just like that the matrix A consists of two numbers which are 1 and -1. On the diagonal of B, the element is -(n-3)/(2(n-2)) while it is 1/(2(n-2)) everywhere else. Again, you may wanna check AB=I, which is the unit matrix.
 
Re: integration problem ..not directly applicable ..not easy

Hey,

i have seen the solution to this problem by somebody on this forum...
just lookout for that post...
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top