Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How do we do noise simulation for circuits like BGR ?

Status
Not open for further replies.
J

jcpu

Full Member level 4
Full Member level 4
Joined
Dec 17, 2005
Messages
214
Helped
18
Reputation
36
Reaction score
5
Trophy points
1,298
Activity points
2,968
Hello

I have a question:
How do we do noise simulation to circuits like BGR
who might not get properly started during AC anaysis
==> getting results with all current ~ zero ...
 

Re: Noise Simulation

Use ac open loop setup.
if u r using spectre , make sure all noise models are on.specify the parameters Noimod =1, Kf =0. Plot against frequency.
 

    J

    jcpu

    Points: 2
    Helpful Answer Positive Rating
Re: Noise Simulation

how to do OPEN LOOP AC simulation,
without affecting noise behavior.
 

Re: Noise Simulation

jcpu said:
how to do OPEN LOOP AC simulation,
without affecting noise behavior.
Click to expand...


break the loop and inject an ac signal of magnitude 1..
the attached doc tells how to do the noise simulation for an opamp. u might get some idea of how to do noise simulation from this.
 

    J

    jcpu

    Points: 2
    Helpful Answer Positive Rating
Re: Noise Simulation

How to do the noise simulation for bandgap circuit using Hspice?

Should a noise generator add on the circuit?

Thx.
 

Re: Noise Simulation

during ac simulation, include this line to simulate noise
.noise v(vo) vsig 1e1

where vsig is your ac signal source in your ac simulation.
 

    J

    jcpu

    Points: 2
    Helpful Answer Positive Rating
Re: Noise Simulation

If I want to get a very low noise voltage reference (less than 10nV), with kind of circuit I should choose: PTAT, Vt/R or something else?

thx!!
 

Re: Noise Simulation

Can we use white gaussion model for testing BGR ckt???
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top