Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
First, I think you know that you are sure that there will be no ground plane on your loop antenna. Otherwise, it will not work.
Second, if you have HFSS, that is going to be very easy. Just put your trace on the pcb substrate.
Third, if you have no HFSS, you can still be able to do it. Find a textbook, trying to find an easy equation (without pcb). It should be close to your desired antenna. Then you can adjust your design. The pcb will just shift the resonant frequency a little bit.
I hope this will help you.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
