Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

what is conventional PCB trace thickness?

Status
Not open for further replies.

jayleung

Member level 5
Member level 5
Joined
Nov 29, 2005
Messages
82
Helped
8
Reputation
16
Reaction score
7
Trophy points
1,288
Activity points
1,962
pcb trace thickness

Hi, everyone. I have a question about the conventional PCB trace thickness. What is the relationship between the thickness and copper weight, since I saw many PCB manufacture give the specification of copper weight. Thanks.
 

pcb copper thickness

35 um is the standard, what is the connection i don't know, may be this is the weight for 1 sq.in or 10 sq.in ..... but 0.035 mm is the standard.
 
  • Like
Reactions: nepdeep

    jayleung

    Points: 2
    Helpful Answer Positive Rating

    nepdeep

    Points: 2
    Helpful Answer Positive Rating
trace thickness

The thickness of copper clad on a circuit board is usually given in ounces (oz). It is the weight of copper on one square foot of board. One ounce copper is 1.378mils (~35um) thick.

Normal PCB copper thicknesses are 1/4oz, 1/2oz, 1oz, and 2oz. Other thicknesses are possible, depending on the capabilities of the fabricator that makes your board. However, copper that is too thick creates lamination problems.

A typical board would use 1/2oz (.7mil or 18um) copper on inner layers, and 1oz (1.4mil or 35um) copper on planes and outside layers. If the board is thin and high density, thinner copper clad would be used to keep the weight and finished board thickness as small as possible.
 
copper trace thickness

For example, check "FAST LINKS TO TECHNICAL SUPPORT" on this PCB manufacturer:
h**p://www.lab-circuits.com/welcom.htm
 
Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top