Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

high current bidirectional switch

Status
Not open for further replies.

fala

Full Member level 5
Full Member level 5
Joined
Sep 18, 2005
Messages
249
Helped
19
Reputation
38
Reaction score
4
Trophy points
1,298
Activity points
3,569
Hello, I want to use a switch for high DC current (+/-1A to +/-3A), and I don't want to use a relay because switch may turns on/off relatively fast and for a long time. should I use a power mosfet? aren't they unidirectional? what is the usual method for switching high DC current bidirectionally? thank you in advance.
 

you can use one N-channel and one P-channel MOSFET in parallel (Source to Drain and Drain to source) and connect 2 transistor gates with use of on inverter together.

see internal circuit of CD4066 IC.

Regards
Davood
 

    fala

    Points: 2
    Helpful Answer Positive Rating
The simplest solution if you dont mind the voltage drop is to use a diode bridge and a power mosfet (or power BJT) to switch the current. To turn on and off the mosfet use an optocoupler to get the neccesary isolation. The biasing of the power transistor is done through the transistor of the optocoupler.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top