Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

How to extract charge from 20 capacitors each 1 V?

Status
Not open for further replies.

mhamini

Member level 1
Member level 1
Joined
Aug 23, 2005
Messages
40
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Location
Iran-Tehran
Activity points
1,690
Can anyone help? I have 20 capacitors joined in parallel, each with 1 volt inside. Can anyone tell me how to extract this charge via the cumulative effect of 20 volts (20 capacitors * 1 volt).
I need a simple low power solution.
 

Re: Capacitor

i think the best way is to solve the circuit in the straight right way . but i can not understand the low power solution. it seems that you havnt passed the electric circuits course yet..!
 

    mhamini

    Points: 2
    Helpful Answer Positive Rating
Re: Capacitor

if your capacitors are parallel to each other and every capacitor have 1 volt potential , the total voltage is also 1 volt and not 20 volt.
 

Re: Capacitor

voltage value is not sufficient alone for computing the charge. you should know at least one another parameter such az capacitance , power or quality factor.
 

Capacitor

Hello mhamini,

I'm not sure, but I understand that you are looking for is a voltage multiplier.
If I'm right, you neet to charge capacitors in parallel and discharge in series.
For the voltage level you indicate, you may use DPDT relays.
For high voltage, you could find usefull a search about "Marx Generator" or "Cockcroft Walton" ....

Best regards
 

    mhamini

    Points: 2
    Helpful Answer Positive Rating
Re: Capacitor

just connect them in series
we went for an IV to DRDO and they use this technique to simulate lightning( they charge capacitor in parallel and connect them in series)
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top