Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

can single input DC 18v~34V to get +5 and +-15V DC output?

Status
Not open for further replies.

air

Member level 3
Member level 3
Joined
Jun 6, 2002
Messages
59
Helped
1
Reputation
2
Reaction score
0
Trophy points
1,286
Activity points
557
Thanks!
 

Re: can single input DC 18v~34V to get +5 and +-15V DC outp

Yes it is possible... what is the output current that you need?
(I assume that you need high current on +5 and low current on +-15V)
//a
 

switch dc-dc converter
 

Re: can single input DC 18v~34V to get +5 and +-15V DC outp

Because of the wide input voltage range I would use simple switcher step-down voltage regulators (for 1A/5V see picture below).
Again, if 1A @ 15V is enough, LM2575-ADJ ( **broken link removed** .. page 12 ) can be the choice, and for negative voltage see inverting regulator (page 20 of the PDF) ..
For 3A current load see: **broken link removed**
For 5A see: **broken link removed**
and so on ..
Regards,
IanP
 

I need this power supply +5v to MCU, LCD, Multiplexer etc. and +-15v to Op Amp. So the current required is not high. I don't know how can I get these three DC voltages at one time. It'll be great if there is a schematic of it available.
 

Re: can single input DC 18v~34V to get +5 and +-15V DC outp

Attached is a schematic of +5, +15 and -15 dc/dc power supply ..
Regards,
IanP
 

    air

    Points: 2
    Helpful Answer Positive Rating
Re: can single input DC 18v~34V to get +5 and +-15V DC outp

Please consider also ON semi IC's... they are cheapest than national IC's,
//a

take a look at w*w.onsemi.com (application notes)
 

Re: can single DC 3v~12v to get 15v DC

hi friends by the way i need to obtain 15v dc from a transformer its output is 12v dc and its current is 400 mA the output current isn't problem but i need to get 15v dc from that output voltage 12v dc i need the answer as quick as possible please
thanks for your time :idea:
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top