Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How to P&R power/ground rings for a multi-voltage chip?

Status
Not open for further replies.
iamchine

iamchine

Junior Member level 2
Junior Member level 2
Joined
Sep 15, 2004
Messages
22
Helped
1
Reputation
2
Reaction score
0
Trophy points
1,281
Location
P.R.China
Activity points
232
For minimum area,how to do it?
1) P&R rings on top-metal round by round?
2) P&R rings on samel round position metal by metal?
3) P&R on top-metal(horizontal) and the next lower(vertical) metal with vias connection to form rings round by round?
Which one is the best? Or any other better way?
Thanks a lot!

BR,
iamchine
 

hi

I don't understand your case,for I haven't seen any standard cells working at 2 or more voltage on the same time in one chip.Or your means that the digital part's voltage is different to the analog part?


Regards

flyankh
 

Re: How to P&R power/ground rings for a multi-voltage ch

hi flyankh,
I mean that digital part's voltage is different from analog IPs' voltage.Though for single voltage supply system,there're at least two rings for power/ground.Somebody told me power/ground rings must be laid on top metal,but I don't think so.I've no layout experience b4.
Thank you!
BR,
iamchine
 

Hi

I think your fullchip floorplan can be decided till the pad location is given .Because the power is from power pad:)
You can make a ring around digital part and another around analog part ,but it maybe use more area in your chip.The ring around analog part sometimes can be canceled and you can connect the power from pad on higher metal,but you must make sure that the IP can work well with the digital noise.

Regards

flyankh
 

    iamchine

    iamchine

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top