Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Some layers' CAM file(.pho and .rep) couldn't generate

Status
Not open for further replies.
E

edaboardman

Junior Member level 3
Junior Member level 3
Joined
May 28, 2005
Messages
26
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,490
how to generate rep file

My top layer and bottomlayer's CAM file(.pho and .rep) couldn't generate,they used no problem before.
PADS report:" Maximum number of apertures exseeded"and stop export gerber file

when I check the target directory, there is only "xxxx.if" file.

why? how to deal with it ?

Thanks!
 

Look at this

JURS
 
the problem disappear strangely ,I don't know why/how/when it disapear......
I don't know wether I should happly or unhappy.
if it apear again, I will try this method!Thanks!
 

Check the aperture wheel settings... The max number of apertures per wheel, defined for the bottom layer would have bee less than the actual number of apertures used by the bottom layer.;
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top