Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
pcb quality depends up on no of factors
1) whether manufacterer able to manufactor board with proscribed design rules
like clearance between wire to wire ,wire to pad ,wire to via ,via to via etc ,
2)min trace width with which he can manufacture
3)min diameter via he can achieve ,bcz for high density interconnect via with dia 6 or 8 mils are used ,this can only achieved by only advance manufactering technology .
4)ability to maitain controled impedance for traces ,
5)multilayer pcb manufactoring capabilty as per ur requirement like 18 layer board
if manufacturer can provide like these facalities then he is ok
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
