Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I used to develop the bridge for the AMBA bus configuration, before end up using the AMBA IP from Synopsys. Whizkid is right, do read the AMBA 2.0 spec and put the emphasis on the bridge as well as the AHB and the APB protocol. Try grasp the basic idea of what the bridge is doing especially on READ/WRITE operations.
You can use this code for reference, as attached.
note: take a close look at the state machine part.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
