Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

extracte on-chip spiral inductor parameters from s-parameter

Status
Not open for further replies.
M

mike_bihan

Full Member level 3
Full Member level 3
Joined
Mar 21, 2002
Messages
182
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,296
Activity points
1,531
About extracting on-chip spiral inductor parameters from measurement!

Any one can share me with the experience of extracting spiral-inductor equivelent from S-parameter?

The case is : After obtaining S-parameter of On-chip CMOS Spiral inductor from measurement, the pad extraction should be done to obtain the accurate result. Then the equivlent circuit should be determined by converting S-param to Y-param, however still many parameters are self-relating.

Have anyone ever seen any paper describing this process in detail? Can you share it with me?

Too many papers about on-chip spiral inductor were published, till now, I have not seen any detail description about this process, why? Is that too simple to discuss?

Thanks!
Bi,Han @ Sjtu,Emlab
 

Eq. circuit extracting

I'm extracting S-pars. from hand-making spiral inductors up to 15 GHz. This procedure looks like:
1. Create a principal eq. circut on the assumption of main physical laws and device geometry.
2. Create a parametric frequency dependence of this parameters. If You don't know this dependence accurately, use polinomial presentation.
3. Optimize all parameters to minimize the difference between analyzed and measured S-pars on the full operating band.

It's all. I can give You example of eq. circuit as MWO project.

With responce,
Kit-the-great
 
re

Define a network structure,than change the parameters to match your
Spara,it can be done by Ansoft softwares or other EDA with optimal
 

Kit-the-great, can you simply post the equations you use (after pads de-embedding of course)?? I use ADS not MWO... thank you a lot

Leron
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top