Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

PA module layout design

Status
Not open for further replies.
B

bouchy

Advanced Member level 4
Full Member level 1
Joined
Jul 11, 2004
Messages
113
Helped
1
Reputation
2
Reaction score
0
Trophy points
1,296
Location
USA
Activity points
794
Hi all,
I am trying to learn how to do board layout, mainly the PA module layout. Any advise where can I start? Any class notes or project will be helpful
Thanks
 

Hi,

If you contact to PA vendors with support of full-version datasheet, then you'll
see their PA module layout.
Basically, PA layout is critical in RF trace, Vbattery and other Vccrouting, and via
holes for thermal and grounding consideration.
Control signals like TDMA bias signals acting as periodicity of on/off switching would be sensitive to any noise ride on and then be modulated toward PA bias causing unwanted spurs.
For high current driving type of PA, Vbattery should take care not only noise isolation but also trace impedance for the sake of voltage supply low drop.

Regards,
 

    B

    bouchy

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top