Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

[SOLVED] what is the voltage across the diode "considering the complete model"

Status
Not open for further replies.

MSAKARIM

Full Member level 3
Full Member level 3
Joined
Jun 2, 2015
Messages
154
Helped
1
Reputation
2
Reaction score
4
Trophy points
1,298
Activity points
2,528
Is this solution right?
1.PNG
2.PNG
 
Last edited:

Solution is wrong. About 0.86 mA If.

No "complete model" is given in your post.
 

    MSAKARIM

    Points: 2
    Helpful Answer Positive Rating
I mean when I replaced the diode with ( small resistance rd'=10 and battery of=0.7v). The diode is forward biased
Solution is wrong. About 0.86 mA If.

No "complete model" is given in your post.
 

That's all correct, but the current is wrong. You ignore the current from the +10V source.
 

    MSAKARIM

    Points: 2
    Helpful Answer Positive Rating
You can replace the diode with a 10 ohm resistor and a 0.7 volt power supply. Then a equation should be solved to find the Voltage across the diode which is:
(-690) / 998 = -0.69138276553
 

    MSAKARIM

    Points: 2
    Helpful Answer Positive Rating
You can replace the diode with a 10 ohm resistor and a 0.7 volt power supply. Then a equation should be solved to find the Voltage across the diode which is:
(-690) / 998 = -0.69138276553
Two rough assumptions (without explanation) - and a result with a pico-volts accuracy.´?
No - without any further information, we have no other chance than to ASSUME 0.7V across the diode and find the current through the diode (method of node voltages): Id=0.86mA.
 

    MSAKARIM

    Points: 2
    Helpful Answer Positive Rating
You can calculate the Thevenin equivalent of the circuit without the diode.
From that you can calculate the current through the diode when it is connected.
 

No - without any further information, we have no other chance than to ASSUME 0.7V across the diode and find the current through the diode (method of node voltages): Id=0.86mA.
Yes. The OP is apparently assuming 0.7V with 10 ohm series resistance as model, without stating this explicitly or even a substantiation. In this case, the exact current would be
4.3 V/5.01 kOhm = 0.858 mA, negligible difference to the simplified calculation without series resistance. Post #5 is wrong in any case.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top