Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

The function of a lock-up latch

Status
Not open for further replies.
R

rakeshnunna

Member level 4
Member level 4
Joined
Apr 19, 2005
Messages
76
Helped
6
Reputation
12
Reaction score
0
Trophy points
1,286
Activity points
1,933
Hi,
A lockup latch is used to prevent data corruption caused by overwriting of new data over the present data before the clock edge occurs.

i.e there is a potential problem of data coming early and overwriting the present actual which has to be fed.

This can be prevented by placing a lock up latch with negative level sensitive D latch connecting the two different chains
 

    A

    akrlot

    Points: 2
    Helpful Answer Positive Rating
lockup latches

DFTC can automated add a lockup latch when your design is multiple clocking .
 

    A

    akrlot

    Points: 2
    Helpful Answer Positive Rating
lock-up latch

thx all.I used the following command to stitch the chains and automatically create a lockup lach:
set_scan_configuration -clock_mixing mix_clocks
 

lockup latch

akrlot said:
hi;
could you explain why a lockup latch is inserted between scan chains with different clocks? and how to stitch two scan chains using a latch with DFTC?
thx
Click to expand...

see material on this page
 

    A

    akrlot

    Points: 2
    Helpful Answer Positive Rating
lock up latches

Lock-up latches are necessary to avoid skew problems during shift phase of
scan test. These problems occur if FF’s driven by different clock lines are
connected within a single scan chain.
For this it is recommended to separate scan chains according clock domains.
If not reasonable lock-up latches have to be inserted into the scan chain. To
allow a smooth scan chain stitching on product level it is recommended to
finish each core level scan chain by a lock-up latch.
 

    A

    akrlot

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top