Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Question about axial ratio

Status
Not open for further replies.
C

cybcad

Member level 2
Member level 2
Joined
Nov 28, 2003
Messages
46
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,288
Activity points
365
axial ratio

i use HFSS to simulate the circular polarization microstrip patch antenna, the eRHCP is more 5dB,and eLHCP is about -3dB, but the axial ratio is 3dB. i want to know how to obtain the axial ratio from the eRHCP and eLHCP. and how to judge the circular polarization is good or not?

regards!


cybcad
 

rhcp axial ratio

If your antenna is a RHCP antenna, only when the difference between
the RHCP and LHCP is more than 15dB, Can the axial ratio be lower
than 3dB. But in your case the difference is just 8 dB, I wonder
how the axial ratio is 3 dB. Can you post the plot?
 
axial ratio db

hi stefen:
can the axial ratio be denoted by

r=(|ERHCP+|ELHCP|)/(|ERHCP|-|ELHCP|)

regards
cybcad
 

axial ratio of rhcp

With HFSS, when you look at axial ratio, which angles I should take for teta and phi ?

Best regards,
Ludovic
 

axial ratio in hfss

hi Ludovic

With HFSS, when you look at axial ratio, which angles I should take for teta and phi ?
Click to expand...

in general, we only care about the axial ratio in the direction of main lobe, so you just take the angles for theta and phi in mainlobe direction. if in the main lobe range the axial ratio is good ,it's enough for you.
 
axial ratio equation

Hi Cybcad,
thanks a lot for your advice
 

hfss axial ratio

Can you tell me how to interpret a 3-D Axial Ratio plot and E-theta, E-Phi plots.

thanks
 
  • Like
Reactions: ahmedy

    A

    ahmedy

    Points: 2
    Helpful Answer Positive Rating
Hi i am simulating a 2.4 GHz circular polarized micostrip antenna on ADS momentum. The axial ratio is only acceptable when theta =90 degree.

Is theta =90 degree or 0 degree the direction of main lobe?
 

Hi, i wonder how did you calculate axial ratio with this expression: r=(|ERHCP+|ELHCP|)/(|ERHCP|-|ELHCP|). In my example, gain of RHCP is -2.65dB and LHCP 7.6dB. However HFSS shows the axial ratio 5.1dB. I cant find where is the problem, am i considering wrong variables in HFSS?
thanks
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top